Index: DamClients/DamUI/trunk/doc/DAM UI - Functional Design/OpenProject.tex
===================================================================
diff -u -r6509 -r6514
--- DamClients/DamUI/trunk/doc/DAM UI - Functional Design/OpenProject.tex	(.../OpenProject.tex)	(revision 6509)
+++ DamClients/DamUI/trunk/doc/DAM UI - Functional Design/OpenProject.tex	(.../OpenProject.tex)	(revision 6514)
@@ -5,8 +5,12 @@
 The project can be saved at a location defined by the user.
 
 \section{Opening a project}
-The user must be able to open an existing project. When calculations were made, also the calculation results must be shown.
-When a project is created in a previous version of DAM (i.e. DAM 18.1 or 19.1), the project cannot be opened and an error message is shown.
-Recreate the project again with the original source data.
-See \autoref{sec:USCreateDesignProject} or \autoref{sec:USCreateCalamityProject}.
+The user must be able to open an existing project. 
+When calculations were made, also the calculation results must be shown.
+The results will not be shown when made by a previous version of \ProgramName, because the results can be outdated. \newline
+\Note{In version 25.1 it is not possible to open previous \ProgramName (*.damx) projects because there were too much changes. 
+A workaround for this is to recreate the project again with the original source data 
+(see \autoref{sec:USCreateDesignProject} or \autoref{sec:USCreateCalamityProject}).}
 
+
+