text/microsoft-resx 2.0 System.Resources.ResXResourceReader, System.Windows.Forms, Version=4.0.0.0, Culture=neutral, PublicKeyToken=b77a5c561934e089 System.Resources.ResXResourceWriter, System.Windows.Forms, Version=4.0.0.0, Culture=neutral, PublicKeyToken=b77a5c561934e089 No input object defined for Sellmeijer 4 Forces No output object defined for Sellmeijer 4 Forces No input object defined for Macro Stability No output object defined for Macro Stability River level ({0}) is below surface level at river side ({1}). Requested kernel not implemented yet Validation failed for location '{0}', subsoil scenario '{1}', design scenario '{2}' No input object defined for Bligh No output object defined for Bligh No output object defined for Sellmeijer VNK No input object defined for Sellmeijer VNK Required safety factor must be specified Location {0}, subsoil scenario '{1}', design scenario '{2}': This calculation in not relevant and thus skipped. Location {0}, subsoil scenario '{1}', design scenario '{2}': The preparation for this calculation failed. The use of Zone Areas is not allowed for stability outside. Model horizontal balance does not support 2d-geometries. No toe of dike has been defined in the surfaceline for location '{0}'. No 1D soilprofile has been defined for location '{0}'. No surfaceline has been defined for location '{0}'. The deepest layer is not an aquifer in soilprofile '{0}'. Specified z-level {0} in AquitardEvaluator is outside soilprofile '{1}' (should be between {2} and {3}). Adapting the slope of the dike failed. Probably the slope is too steep or too shallow. The ditch as part of the surface line is incorrect. This makes a redesign of the surface line impossible. No valid dike. Dike top polder or river has a height of 0. The new slope of the ditch does not intersect with the surface line (new bottom of ditch probably to high). This makes a redesign of the surface line impossible. There is no valid dike defined. Missing characteristic points dike toe at polder, dike top at river, dike top at polder and/or dike toe at river. The surface line is null or empty. No valid point data in the surface line. It should have at least 4 points to be valid. The shoulder defined on the dike is not valid. The height is zero. There is no surface level inside defined on the dike. After height adaption ditch does not fit inside surfaceline anymore. After height adaption ditch does not fit inside surfaceline anymore. The heigth of the dike top is equal to or lower than the dike toe so redesign is NOT possible. New shoulder height is smaller than current shoulder height. The new shoulder height is too large to fit in the current surface line. The new shoulder height with topslope exceeds the allowed maximum height. New shoulder height should be larger than 0. The new shoulder does not intersect the surface. This can be caused by a very strange surfaceline or the new shoulderwidth is too large. New shoulder width is smaller than current shoulder width. The new shoulder width is too large to fit in the current surface line. No Dam input object defined for Bligh The design was not successful in location '{0}', soilprofile '{1}' Factor achieved = {0:0.000}, Factor required = {1:0.000}. Not all required data is available No Dam input object defined for Macro Stability Maximum design iterations ({0} exceeded. A kernel calculation failed. Initial geometry file (sti) is not created. Design not support for this model ({0}). Required safety factor must be specified.